Measurement Guide

Measuring for your dogs muzzle can be a daunting task, with so many different ways to get
your desired sizing. We have put together a guide to explain each step to ensure the best
possible fit. Please take your time to read through the guide properly, and follow the
instructions to the best of your ability. Each manufacturer will have different requirements,
so please only enter the sizes we have asked for. Our goal is to create the perfect muzzle for
your dog, so if you require any additional help or are unsure of any of the sizing
requirements, please don’t hesitate to get in touch and a member of our team will be more
than happy to help you.

All measurements should follow the arrows shown on the diagrams below, and be either straight horizontal, or straight vertical. Please try not to bend the tape or measure diagonally.


This guide is also available as a PDF download.

SHOP NOW

#1 Snout Width

Measure in a straight line across the snout. This is a tight measurement of the snout where the muzzle will rest. You do not need to allow for curvature or clearance.

#2 Jaw Width

Measure in a straight line underneath the jaw. This will help create flare in the muzzle, opening out towards the bottom. The wider the jaw, the greater the flare.

#3 Snout Length

Measure from the tip of the nose (Point A) to the point you wish the muzzle to stop (Point B). Ensure it will not irritate the eyes.

#4 Jaw Length

Measure in line with Point A back under the length of the jaw, leaving sufficient clearance to the neck. Do not bend the tape around the end of the snout, keep it straight.

#5 Strap Position

Measure from Point B down to and in line with the corner of the mouth or just below the jaw hinge (TMJ). The treat hole will be positioned just above this point too.

#6 Overall Length

Measure from Point A to Point C. This is approximately the cheek.

#7 Pant Height

Measure in a straight line down from Point A to the bottom of the jaw when the dog is at the desired pant for the intended use.

A muzzle that is to be worn for longer periods (walks etc) should allow “Full Pant”. Exercise your dog for a short period to encourage panting or use an appropriate size toy in their mouth or under their jaw to simulate the pant.

#8 Neck Strap

Measure from Point C around the back of the head to Point C on the opposite side.

#9 Chin Strap

Measure from Point C underneath the jaw to Point C on the opposite side.

#10 Head Strap

Measure from Point B to the back of the head where it would intercept the neck strap.

For further assistance please get in touch